Carter-hoffmann CW4 Bedienungsanleitung

OWNERS / OPERATORS MANUAL for Chip Warmers Models: CW1, CW2E and CW4 Part Number: 18400-3051

10 DAILY CLEANING PROCEDURES 1. Turn the power switch to “OFF” and allow the cabinet to cool. 2. Unplug the unit prior to any cleaning. 3. Remove a

11 MONTHLY CLEANING PROCEDURES RECOMMENDED TIPS FOR CLEANING STAINLESS STEEL Purpose Frequency Cleaning Agent Method of Applica

12 CW2E & CW4: 1530 watts, 120 volts, 12.8 A, 60 Hz, 1Ph CW1: 1040 watts, 120 volts, 8.7 A, 60 Hz, 1Ph

13 CW2E & CW4 with digital control: 1530 watts, 120 volts, 12.8 A, 60 Hz, 1Ph

14 TROUBLESHOOTING GUIDE SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY No power to unit Not plugged in or circuit breaker tripped Check or reset circu

15 Carter-Hoffmann Warranty: Carter-Hoffmann (“CARTER-HOFFMANN”) warrants to the initial purchaser of its standard Carter Line Products that CARTER-HO

2 WARNING: ELECTRIC SHOCK HAZARD All service requiring access to non-insulated components must be performed by qualified service personnel. Failure

3 FEATURES & SPECIFICATIONS Model Number Chip Capacity Cubic feet Gallons Overall Dimensions Height * Depth

4 UNPACKING AND INSPECTION FREIGHT DAMAGE PROCEDURE NOTE: For your protection, please note that equipment in this shipment was carefully inspected

3 Location For proper operation and maximum performance, locate the unit in an ambient air temperature of 70°F (21°C). Avoid placement in areas ne

6 STARTUP 1. For the CW2E and CW4, Install 12”x20” crumb pan (included) under the cabinet. Cabinet performance will be severely affected if the pan

7 NORMAL OPERATION FOR UNITS WITH THERMOSTATIC CONTROLS THERMOSTAT CALIBRATION If additional heat range is required in the cabinet, unplug the heatin

8 NORMAL OPERATION FOR UNITS WITH DIGITAL CONTROLS NOTE : controllers may be are used without the decal so button posi-tions need to be

9 PROGRAMMING INSTRUCTIONS (Units with Digital Controls) To Change the Temperature Range: The temperature range is the range that the cabinet is desi